Directions for Installing Vinyl

Thanks for ordering from BushCreative. Below are the directions for application of your custom vinyl

lettering. If you have any questions please feel free to contact us. Vinyl is safe for most wall

applications, but can not be reused once removed. On rare occasions after removal some touch up paint

will need to be done to some types of paint applications.

Directions:

If Vinyl has been shipped, or rolled up for any period of time, lay flat and allow to

acclimate over night before application.

For best results, pre-measure the location for your lettering, using a level and ruler.

Mark position with a pencil. Make sure surface where lettering will be applied is clean,

dry and smooth.

Rub over the lettering with a credit card or plastic spatula.

Tape vinyl with backing paper still in place in desired location, with 2 small pieces of

tape in upper corners.

When in desired location, tape in place using a long piece of tape, run vertically down

center of vinyl.

Starting on the right side pull vinyl away from backing while left side stays in place.

Tear off backing paper, then slowly lay vinyl lettering on wall from center, while

rubbing up and down as you go.

Repeat with other side, removing all of backing paper.

Slowly peel off the transfer tape at an angle, re-rub any lettering that sticks to the tape

and re-apply pressure to lettering.

You're done!